Table of Contents
Advertisement
5. Press 1 to download the agent firmware. The following messages display:
(D)ownload System Image or (S)tart Application:
Select the Firmware Type to Download (1)Runtime (2)POST
Your Selection: Runtime Code
Download code to FlashROM address 0xff200000
Change Baud Rate to 115200 and Press <ENTER> to Download.
6. Change your terminal baud rate to 115200 bps and press ENTER.
7. Send the file using the XMODEM protocol from your computer application (the procedure
varies depending upon the application used).
8. When the XMODEM procedure finishes, the following messages display:
Verifying image in DRAM download buffer 0x01000000... SUCCESS !
Update FlashROM Image at 0xFF200000 ...
Erasing 3 FlashROM Blocks at 0xFF200000 ...
Writing FlashROM Image at 0xFF200000 ... SUCCESS !
Erasing 3 FlashROM Blocks at 0xFF500000 ...
Writing FlashROM Image at 0xFF500000 ... SUCCESS !
Change Baud Rate to 9600 and Press <ENTER>.
9. Change your terminal baudrate back to 9600 and press ENTER. The following message
displays:
(D)ownload another Image or (S)tart Application:
10.Press S to start the application.
3.2.3.2
Downloading via TFTP
To perform a TFTP download, you must first set the device's IP address (as detailed in
Section
3.2.2.23). You then use the dload command to enter the IP address of the TFTP server and
the name of the image file.
dload
Use this command to download a new firmware image from a TFTP server to the device.
dload hostname | ip-address filename [noreboot]
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
General Configuration Command Set
Downloading a Firmware Image
[
]
S
[
]
S
[
]
1
:
3-51
Advertisement
Table of Contents
