6.2.1.18 show spantree bridgehellomode
Use this command to display the status of bridge hello mode on the device. When enabled, a single
bridge administrative hello time is being used. When disabled, per-port administrative hello times
are being used.
show spantree bridgehellomode
Syntax Description
None.
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display the Spanning Tree bridge hello mode. In this case, a single
bridge hello mode has been enabled using the set spantree bridgehellomode command as
described in
Section
Matrix>show spantree bridgehellomode
Bridge Hello Mode is currently enabled.
6.2.1.19 set spantree bridgehellomode
Use this command to enable or disable bridge hello mode on the device.
set spantree bridgehellomode {enable | disable}
Syntax Description
enable
disable
Command Defaults
None.
6.2.1.21:
Enables single Spanning Tree bridge hello mode.
Disables single Spanning Tree bridge hello mode, allowing
for the configuration of per-port hello times.
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
Spanning Tree Configuration Command Set
Reviewing and Setting Spanning Tree Bridge Parameters
6-21