Table of Contents
Advertisement
Port Configuration Command Set
Setting Port Auto-Negotiation and Advertised Ability
4.3.5.4
set port advertised ability
Use this command to enable or disable and to configure the advertised ability on one or more ports.
set port advertised ability port-string {10 | 100 | 1000 | all} {half | full | all}
{flowcontrol} {disable | enable}
Syntax Description
port-string
10 | 100 | 1000 |
all
half | full | all
flowcontrol
disable | enable
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to disable Fast Ethernet front panel port 1 from advertising any speed or
duplex settings:
Matrix>set port advertised ability fe.0.1 all disable
4-26
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
Specifies the port(s) for which to enable, disable or
configure advertised ability. For a detailed description of
possible port-string values, refer to
Specifies a speed for the port to advertise in Mbps, or
enables the port to advertise all the speeds at which it can
operate.
Specifies a duplex mode for the port to advertise, or enables
the port to advertise all the duplex modes at which it can
operate.
Specifies flow control for advertisement.
Disables or enables advertised ability with the parameters
specified.
Section
4.1.2.
Advertisement
Table of Contents
