Table of Contents
Advertisement
4.3.13 Configuring Link Aggregation
Purpose
To disable and re-enable the Link Aggregation Control Protocol (LACP), to display and configure
LACP settings for one or more aggregator ports, and to display and configure the LACP settings for
underlying physical ports that are potential members of a link aggregation.
NOTE: Commands with the keyword lacp can only be used when the device is in
802.3ad mode. This mode can be reset using the set trunkmode command as
described in
Commands
The commands used to review and configure LACP are listed below and described in the associated
section as shown.
•
set lacp
(Section
•
set lacp static
(Section
•
clear lacp static
(Section
•
show port lacp
(Section
•
set port lacp
(Section
4.3.13.1 set lacp
Use this command to disable or enable the Link Aggregation Control Protocol (LACP) on the
device.
set lacp {disable | enable}
Syntax Description
disable | enable
Command Defaults
None.
Command Type
Switch command.
Section
4.3.11.2.
4.3.13.1)
4.3.13.2)
4.3.13.3)
4.3.13.4)
4.3.13.5)
Disables or enables LACP.
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
Port Configuration Command Set
Configuring Link Aggregation
4-63
Advertisement
Table of Contents
