Set Telnet - Enterasys 1G58x-09 Configuration Manual

Telnet sessions have not been changed from the default value of 4. For details on using the set telnet
command to change default settings, refer to
Matrix>show telnet
Inbound telnet is currently enabled on port 23.
Outbound telnet is currently enabled.
Maximum inbound telnet sessions
Maximum outbound telnet sessions = 4.
Maximum ssh telnet sessions
3.2.4.2

set telnet

Use this command to configure Telnet on the device.
set telnet {[disable | enable] inbound | outbound | all} | port port | session
{inbound | outbound | ssh}session}
Syntax Description
disable | enable
inbound | outbound |
all
port port
session inbound |
outbound | ssh
session
Command Defaults
None.
Command Type
Switch command.
Section
Disables or enables Telnet services.
Disables or enables inbound service (the ability to Telnet
to this device), outbound service (the ability to Telnet to
other devices), or all (both inbound and outbound).
Sets the Telnet listening port. Valid values are:
•
port number 1024 to 65535, or
•
default (port number 23)
Sets the maximum number of inbound sessions (the
ability to Telnet to this device), outbound sessions (the
ability to Telnet to other devices), or SSH (Secure Shell)
sessions. Valid values are 0 to 4. For more information on
configuring SSH, refer to
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
General Configuration Command Set
3.2.4.2:
= 4.
= 4.
Section
Configuring Telnet
14.3.6.
3-55