Set Spantree Autoedge; Clear Spantree Autoedge - Enterasys 1G58x-09 Configuration Manual

Spanning Tree Configuration Command Set
Reviewing and Setting Spanning Tree Bridge Parameters

6.2.1.28 set spantree autoedge

Use this command to enable or disable the automatic edge port detection function.
set spantree autoedge {disable | enable}
Syntax Description
disable | enable
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to disable automatic edge port detection:
Matrix>set spantree autoedge disable

6.2.1.29 clear spantree autoedge

Use this command to reset automatic edge port detection to the default state of enabled.
clear spantree autoedge
Syntax Description
None.
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
6-28 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
Disables or enables automatic edge port detection.