12.2.1.3 show ip interface
Use this command to display information, including administrative status, IP address, name, MTU
size and bandwidth, for interfaces configured for IP.
show ip interface [vlan vlan_id | loopback loopback-id]
Syntax Description
vlan vlan_id |
loopback
loopback-id
Command Type
Router command.
Command Mode
Privileged EXEC: Matrix>Router#
Command Defaults
If not specified, status information for all interfaces will be displayed.
Example
This example shows how to display configuration information for all VLANs configured for IP
routing:
Matrix>Router#show ip interface
Vlan 1 is
Internet Address is 182.127.63.1, Subnet
The name of this device is
The MTU is 1500 bytes
The bandwidth is 10000
Vlan 2 is
Internet Address
The name of this device is
The MTU is 1500 bytes
The bandwidth is 10000
(Optional) Displays interface information for a specific
VLAN or loopback. This interface must be configured for IP
routing as described in
Admin UP
Admin UP
is 182.127.62.1, Subnet
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
IP Configuration Command Set
Configuring Routing Interface Settings
Section
3.3.2.
Mask is 255.255.255.0
Vlan
Mask is 255.255.255.0
Vlan
12-7