Table of Contents
Advertisement
General Configuration Command Set
Setting Basic Device Properties
3.2.2
Setting Basic Device Properties
Purpose
To display and set the basic system (device) information, including password, system time, system
prompt, contact name, terminal output, lockout time, timeout, console baud rate and version
information, to display or set the system IP address, and to download a new firmware image to the
device.
Commands
The commands needed to set basic system information are listed below and described in the
associated section as shown.
•
show system resources
•
show time
(Section
•
set time
(Section
•
set prompt
(Section
•
show banner motd
•
set banner motd
•
clear banner motd
•
show version
(Section
•
set system name
•
set system location
•
set system contact
•
show terminal
(Section
•
set terminal
(Section
•
set system timeout
•
set console baud
•
show ip address
•
set ip address
(Section
3-30
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
(Section
3.2.2.1)
3.2.2.3)
3.2.2.4)
3.2.2.5)
(Section
3.2.2.6)
(Section
3.2.2.7)
(Section
3.2.2.8)
3.2.2.9)
(Section
3.2.2.10)
(Section
3.2.2.11)
(Section
3.2.2.12)
3.2.2.13)
3.2.2.14)
(Section
3.2.2.15)
(Section
3.2.2.21)
(Section
3.2.2.22)
3.2.2.23)
Advertisement
Table of Contents
