Table of Contents
Advertisement
Port Configuration Command Set
Enabling / Disabling Jumbo Frame Support
Example
This example shows how to set Fast Ethernet front panel port 17 to full duplex:
Matrix>set port duplex fe.0.17 full
4.3.4
Enabling / Disabling Jumbo Frame Support
Purpose
To review, enable, and disable jumbo frame support on all ports. This allows ports to transmit
frames up to 6 KB in size.
Commands
The commands used to review, enable and disable jumbo frame support are listed below and
described in the associated section as shown.
•
show port jumbo
•
set port jumbo
(Section
4.3.4.1
show port jumbo
Use this command to display the status of jumbo frame support and maximum transmission units
(MTU) on one or more ports.
show port jumbo
Syntax Description
None.
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Only.
4-18
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
(Section
4.3.4.1)
4.3.4.2)
Advertisement
Table of Contents
