General Configuration Command Set
Pausing, Clearing and Closing the CLI
3.2.7
Pausing, Clearing and Closing the CLI
Purpose
To pause or clear the CLI screen or to close your CLI session.
Commands
The commands used to pause, clear and close the CLI session are listed below and described in the
associated sections as shown.
•
wait
(Section
3.2.7.1)
•
cls
(Section
3.2.7.2)
•
exit
(Section
3.2.7.3)
3.2.7.1
wait
Use this command to pause the CLI for a specified number of seconds before executing the next
command.
wait seconds
Syntax Description
seconds
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to pause the CLI for 10 seconds:
Matrix>wait 10
Wait for 10 seconds . . .
3-84
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
Specifies the number of seconds for the CLI to pause
before executing the next command