Table of Contents
Advertisement
Logging and Network Management Command Set
Configuring System Logging
Syntax Description
None.
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This command shows how to display the Syslog server default values. For an explanation of the
command output, refer back to
Matrix>show logging default
Facility
-----------------------------------------------------------
Defaults:
local7
NOTE: Most system messages are logged at severity level of 6 (Notice). By default,
the logging applications are set to 5 (Warning), which will suppress level 6 (Notice)
messages from the console session. To view most of the logging of configuration
messages on the console session, ACL hits etc., the set logging application
command should be used as described in
applications to 6 or higher.
11.2.1.9 set logging default
Use this command to set logging default values.
set logging default {facility facility | severity severity | port port}
11-12
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
Table
11-1.
Severity
warnings(5)
Port
514
Section 11.2.1.12
to set the logging level for
Advertisement
Table of Contents
