Table of Contents
Advertisement
IP Configuration Command Set
Configuring Routing Interface Settings
12.2.1.2 interface
Use this command to enable interface configuration mode from global configuration mode. For
details on configuration modes supported by the Matrix E1 device and their uses, refer to
in
Section
3.3.3.
interface vlan vlan_id | loopback loopback-id
NOTES: VLANs must be created in switch mode before they can be configured for IP
routing. For details on creating VLANs and configuring them for IP, refer to
Section
3.3.2.
Each VLAN or loopback interface must be configured for routing separately using the
interface command. To end configuration on one VLAN before configuring another,
type exit at the command prompt. Enabling interface configuration mode is required for
completing interface-specific configuration tasks. For an example of how these
commands are used, refer to
Syntax Description
vlan vlan_id |
loopback
loopback-id
Command Type
Router command.
Command Mode
Global configuration mode: Matrix>Router(config)#
Command Defaults
None.
Example
This example shows how to enter configuration mode for VLAN 1:
Matrix>Router#configure terminal
Matrix>Router(config)#interface vlan 1
Matrix>Router(config-if(Vlan 1))#
12-6
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
Figure 3-7
in
Section
Specifies the VLAN or loopback interface to be configured
for routing. This interface must be configured for IP routing
as described in
Section
3.3.2.
3.3.2.
Table 3-10
Advertisement
Table of Contents
