Logging and Network Management Command Set
Configuring Convergence End Points (CEP) Phone Detection
Syntax Description
detection-id
tcp | udp | both |
none
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to enable both TCP and UDP convergence end points detection for CEP
:
detection group 1
Matrix>set cep detection 1 protocol both
11.2.6.9 set cep detection porthigh
Use this command to set the maximum and minimum ports used for TCP or UDP convergence end
points detection. Once UDP and/or TCP phone detection has been specified using the set cep
detection protocol command as described in
for detection matching.
set cep detection detection-id {porthigh | portlow port}
NOTE: This command applies only to Siemens and H.323 phone detection. Cisco
detection uses CiscoDP as its discovery method.
11-82
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
Specifies a CEP discovery group ID. This group must be
created and enabled using the set cep detection command
as described in
Section
2147483647.
Sets the CEP IP protocol type as:
•
TCP
•
UDP
•
Both UDP and TCP
•
None
Section
11.2.6.8, the protocols will use this port range
11.2.6.5. Valid values are 1 -