Novell NETWARE 6-DOCUMENTATION Manual page 3621

588: The system was unable to parse the specified path.
Source:
Possible Cause:
Action:
589: The system received an invalid path for the current server mode.
Source:
Possible Cause:
Action:
590: An error occurred while attempting to build a class list. It is likely that the
workstation is out of memory.
Source:
Possible Cause:
Action:
591: The path must contain a full drive specification, including a :.
Source:
Possible Cause:
Action:
670 System Messages
utility name in message prefix
The program could not find the directory path because the user specified a
directory path that does not exist or mistyped the directory path.
Use the FILER utility to examine the directory. Type the directory path
correctly. The correct syntax is as follows:
Server\ volume:
or
Drive: directory\
The user can use the MAP command or the NETUSER utility to map a
network drive to a directory; then the user can specify the drive, rather than
the directory path, in the command.
utility name in message prefix
This is probably an internal error in the program.
Try again. If the problem persists, contact a Novell support provider.
utility name in message prefix
The workstation does not have enough memory.
Increase the memory available to the workstation. See
Workstation Memory Problems" on page
utility name in message prefix
The user specified an incomplete drive designation.
Specify a complete designation. Be sure the drive name is followed by a colon
(:).
directory\ subdirectory\
subdirectory\
787.
file
file
"Resolving