Novell NETWARE 6-DOCUMENTATION Manual page 2590

To
Close the recording session and save it as
SYS:SYSTEM\MYLIST1.NCF
Execute the list of commands in the MYLIST1
session
Save the MYLIST1 session that has already been
closed to SYS:SYSTEM\MYLIST1.NCF.
Additional Information
REGISTER MEMORY
Purpose
Syntax
152 Utilities Reference
For information, see
Use at the server console to configure the operating system to recognize
installed memory above the amount of memory that is automatically
registered. NetWare
IMPORTANT:
Use the REGISTER MEMORY command only if absolutely
necessary. Manually registering memory can cause memory fragmentation.
Ideally, you should upgrade the system board so that NetWare's automatic memory
registration will work.
Before using REGISTER MEMORY, try the following:
Review the CONFIG.SYS or AUTOEXEC.BAT files to make sure
nothing is being loaded on the server that prevents memory recognition:
sometimes a real mode driver or a memory manager stops NetWare from
registering memory above 64 MB.
If your server contains an older network board, such as many ISA and
MCA devices, upgrade to a newer board.
If you have access to the World Wide Web, search the knowledge base at
http://support.novell.com for Register Memory topics.
REGISTER MEMORY start_address amount
Enter
RECORD STOP NCF
REPLAY MYLIST1
RECORD SAVE MYLIST1
"REPLAY" on page
®
6 can address up to 4 GB.
162.