QoS Policy Commands
policy condition destination vlan
Configures a destination VLAN for a policy condition. Note that this condition is supported only in
combination with a multicast condition (multicast ip, multicast ipv6, or multicast network group).
policy condition condition_name destination vlan vlan_id
policy condition condition_name no destination vlan
Syntax Definitions
condition_name
vlan_id
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
•
Use the no form of this command to remove a destination VLAN from a condition; however, at least
one classification parameter must be associated with a condition.
•
Note that this condition is supported for multicast only policies.
Examples
-> policy condition cond4 destination vlan 3 multicast ip any
Release History
Release 6.6.1; command was introduced.
Related Commands
qos apply
policy condition
show policy condition
OmniSwitch CLI Reference Guide
The name of the condition. May be an existing condition name or a new
condition.
The destination VLAN ID for the flow.
Applies configured QoS and policy settings to the current configuration.
Creates a policy condition.
Shows information about policy conditions configured on the switch.
November 2009
page 39-97