Table of Contents
Advertisement
Interfaces
2. At the Admin CLI prompt, type :
> show surelink interface all
Interface
---------
wan1
wan1
lan1
lan1
wwan1
wwan1
>
3. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Show SureLink status for a specific interface
To show the SureLink status a specific interface, use the
command:
1. Select the device in Remote Manager and click Actions > Open Console, or log into the TX40
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. Use the
show surelink interface name name
interface, for example:
> show surelink interface name wan1
wan1 Surelink Status
--------------------
IPv4 Status : Passing
IPv6 Status : Failed
Test
-----------------------------
Interface's DNS servers (DNS)
>
3. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Show SureLink status for all IPsec tunnels
To show the SureLink status all IPsec tunnels, use the
TX40 User Guide
Test
-----------------------------
Interface is up
Interface's DNS servers (DNS)
Interface is up
Interface's DNS servers (DNS)
Interface is up
Interface's DNS servers (DNS)
Proto
-----
IPv6
Show SureLink status and statistics
Proto
Last Response
-----
-------------
IPv4
32 seconds
IPv4
28 seconds
IPv4
21 seconds
IPv4
20 seconds
IPv4
115 seconds
IPv4
114 seconds
show surelink interface name name
command to show the Surelink status of a specific
Last Response
Status
-------------
------
15 seconds
Failed
show surelink ipsec all
Status
-------
Passing
Passing
Passing
Passing
Passing
Passing
command:
232
Advertisement
Table of Contents
