Digi TX40 User Manual page 378

Hotspot
8. Set the authentication mode:
(config network hotspot new_hotspot)> auth value
(config network hotspot new_hotspot)>
where value is one of:
n click_through: Requires each user to accept the terms and conditions.
n local_shared_password: Requires each user to enter a password. This password is
validated locally on the TX40 device, and the password is the same for all users.
See
about configuring hotspot for local shared password authentication.
n radius_shared_password: Requires each user to enter a password. This password is
validated by an external RADIUS server, and the password is the same for all users.
See
information about configuring hotspot for RADIUS shared password authentication.
n radius_user: Requires each user to enter username and password credentials that are
established on an external RADIUS server. The credentials are validated by the RADIUS
server.
See
configuring hotspot for RADIUS users authentication.
hotspotsystem: Requires each user to be authenticated by HotspotSystem, a cloud
n
hotspot service that supports various free and paid authentication methods, including
social media account, SMS, voucher, and PayPal.
See
configuring hotspot for HotspotSystem authentication.
9. Set the login page source. (This option is not available if auth is set to hotspotsystem.)
(config network hotspot new_hotspot)> login value
(config network hotspot new_hotspot)>
where value is either:
local: Uses an HTML page for authentication that is stored locally on the TX40 device's
n
filesystem, in the /etc/config/hotspot directory. Note that the hotspot directory is not
visible until hotspot has been enabled for the first time.
remote: Uses an HTML page for authentication that is served by a remote web server.
n
10. (Optional) If local is selected for login, set the name of the local HTML file used for
authentication. (This option is not available if auth is set to hotspotsystem.)
(config network hotspot new_hotspot)> local_page HTML_filename
(config network hotspot new_hotspot)>
Normally, this parameter should be left blank, and the device will use the default
authentication HTML page. See
default authentication HTML page used for each authentication mode.
If you upload a custom HTML file that uses a filename other than the default filename, type the
custom filename here. See
creating and uploading custom HTML files.
TX40 User Guide
Configure the hotspot to use local shared password authentication
Configure the hotspot to use RADIUS shared password authentication
Configure the hotspot to use RADIUS users authentication
Configure the hotspot to use HotspotSystem authentication
Hotspot authentication modes
Upload custom hotspot HTML pages
Hotspot configuration
for information
for
for information about
for information about
for information about the
for more information about
378