Table of Contents
Advertisement
Interfaces
f. Repeat for each additional test.
6. Add recovery actions:
a. Type ... to return to the root of the configuration:
(config network interface my_wan surelink tests 1)> ...
(config)>
b. Add a recovery action:
(config)> add network interface my_wan surelink actions end
(config network interface my_wan surelink actions 0)>
c. New actions are enabled by default. To disable:
(config network interface my_wan surelink actions 0)> enable false
(config network interface my_wan surelink actions 0)>
d. Create a label for the action:
(config network interface my_wan surelink actions 0)> label string
(config network interface my_wan surelink actions 0)>
e. Set the type of recovery action. If multiple recovery actions are configured, they are
performed in the order that they are listed. The command varies depending on whether
the interface is a WAN or WWAN:
n
n
where value is one of:
n
TX40 User Guide
o
up: The test will pass only if the referenced interface is up and passing its
own SureLink tests (if applicable).
o
down: The test will pass only if the referenced interface is down or failing its
own SureLink tests (if applicable).
WAN interfaces:
(config network interface my_wan surelink actions 0)> action
value
(config network interface my_wan surelink actions 0)>
WWAN interfaces:
(config network interface my_wan surelink actions 0)> modem_
action value
(config network interface my_wan surelink actions 0)>
update_routing_table: Increases the interface's metric to change the default
gateway.
If update_routing_table is selected, complete the following:
Set the number of attempts for this recovery action to perform, before moving
l
to the next recovery action:
Wide Area Networks (WANs)
88
Advertisement
Table of Contents
