Show Lan Status And Statistics - Digi IX20-WAG4 User Manual

Interfaces
(Optional) Configure the MAC address allowlist.
If there allowlist entries are specified, incoming packets will only be accepted from the listed
MAC addresses.
a. Add a MAC address to the allowlist:
(config network interface my_lan)> add mac_allowlist end mac_address
(config network interface my_lan)>
where mac_address is a hyphen-separated MAC address, for example, 32-A6-84-2E-81-58.
b. Repeat for each additional MAC address.
8. Save the configuration and apply the change:
(config network interface my_lan)> save
Configuration saved.
>
9. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Show LAN status and statistics


WebUI
1. Log into the IX20 WebUI as a user with Admin access.
2. From the menu, click Status.
3. Under Networking, click Interfaces.

Command line
1. Log into the IX20 command line as a user with Admin access.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. Enter the show network
> show network
Interface
----------------
defaultip
defaultlinklocal
eth1
eth1
eth2
eth2
loopback
modem
modem
IX20 User Guide
command at the Admin CLI prompt:
Proto Status Address
----- ------- -------------------------------
IPv4 up 192.168.210.1/24
IPv4 up 169.254.100.100/16
IPv4 up 10.10.10.10/24
IPv6 up fe00:2404::240:f4ff:fe80:120/64
IPv4 up 192.168.2.1/24
IPv6 up fd00:2704::1/48
IPv4 up 127.0.0.1/8
IPv4 up 10.200.1.101/30
IPv6 down
Local Area Networks (LANs)
137