Table of Contents
Advertisement
User authentication
n
Enable command accounting, so that the device will communicate with the TACACS+ server to
log commands that the user executes. Beginning with firmware release 21.11.x, python is no
longer included as part of the base firmware for the TX40 device. If you require Python in your
environment and your device is running firmware 21.11.x or newer, see
information about installing Python on your device.
n
The TACACS+ server port. It is configured to 49 by default.
Add additional TACACS+ servers in case the first TACACS+ server is unavailable.
n
Web
1. Log into Digi Remote Manager, or log into the local Web UI as a user with full Admin access
rights.
2. Access the device configuration:
Remote Manager:
a. Locate your device as described in
device.
b. Click the Device ID.
c. Click Settings.
d. Click to expand Config.
Local Web UI:
a. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Authentication > TACACS+ > Servers.
4. Add TACACS+ servers:
a. For Add server, click .
b. For Hostname, type the hostname or IP address of the TACACS+ server.
c. (Optional) Change the default Port setting to the appropriate port. Normally this should be
left at the default setting of port 49.
TX40 User Guide
Terminal Access Controller Access-Control System Plus (TACACS+)
Use Digi Remote Manager to view and manage your
Install Python
for
867
Advertisement
Table of Contents
