Table of Contents
Advertisement
Services
5. Save the configuration and apply the change
(config)> save
Configuration saved.
>
6. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Configure the internal GNSS module
The internal GNSS module is enabled by default. You can disable it, or you can enable it if it has been
disabled.
Note
In order for the internal GNSS module to be able to provide location information, you must
connect an antenna to the GNSS antenna connector.
Web
1. Log into Digi Remote Manager, or log into the local Web UI as a user with full Admin access
rights.
2. Access the device configuration:
Remote Manager:
a. Locate your device as described in
device.
b. Click the Device ID.
c. Click Settings.
d. Click to expand Config.
Local Web UI:
a. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Services > Location > Location sources > gnss.
4. (Optional) Type a Label for the GNSS location source.
5. For Type of location source, leave the selection at GNSS.
6. Click Enable the location source to disable the internal GNSS module, or to enable it if it has
been disabled.
TX40 User Guide
Use Digi Remote Manager to view and manage your
Location information
676
Advertisement
Table of Contents
