Isolate Clients Connected To The Same Access Point - Digi TX40 User Manual

Wi-Fi
n

Isolate clients connected to the same access point

n Isolate clients connected to different access points
This section provides instructions for both mechanisms.
Isolate clients connected to the same access point

Web
1. Log into Digi Remote Manager, or log into the local Web UI as a user with full Admin access
rights.
2. Access the device configuration:
Remote Manager:
a. Locate your device as described in
device.
b. Click the Device ID.
c. Click Settings.
d. Click to expand Config.
Local Web UI:
a. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Network > WiFi > Access points.
4. Create a new access point or modify an existing access point. See
access point,
point with enterprise
5. Enable Isolate clients.
6. Click Apply to save the configuration and apply the change.

Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the TX40
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
TX40 User Guide
Use Digi Remote Manager to view and manage your
Configure a Wi-Fi access point with personal
security.
Isolate Wi-Fi clients
Configure an open Wi-Fi
security, or Configure a Wi-Fi access
331