Digi TX40 User Manual page 804

Applications
"coordinates" [
]
},
"properties": {
"direction": "None",
"horizontal_velocity": "0.0",
"latitude.deg_min_sec": "44* 54' 45.586\" N",
"longitude.deg_min_sec": "93* 33' 52.334\" W",
"num_satellites": "12",
"quality": "Standard GNSS (2D/3D)",
"selected_source_idx": "0",
"source": "USB (/dev/ttyACM0)",
"source_idx.0.altitude": "273.200012",
"source_idx.0.direction": "None",
"source_idx.0.horizontal_velocity": "0.195489",
"source_idx.0.label": "usb",
"source_idx.0.latitude": "44.902662",
"source_idx.0.latitude.deg_min_sec": "44* 55' 45.065\" N",
"source_idx.0.longitude": "-93.560648",
"source_idx.0.longitude.deg_min_sec": "93* 16' 52.966\" W",
"source_idx.0.num_satellites": "12",
"source_idx.0.quality": "Standard GNSS (2D/3D)",
"source_idx.0.utc_date_time": "Sept-29-2023 12:10:00",
"source_idx.0.vertical_velocity": "0.0",
"source_idx.1.label": "gnss",
"source_idx.1.quality": "No Fix / Invalid",
"state": "Enabled, signal",
"utc_date_time": "Sept-29-2023 12:10:00",
"vertical_velocity": "0.0"
}
}
>>>
6. Use Ctrl-D to exit the Python session. You can also exit the session using exit() or quit().
Help for the digidevice location module
Get help for the digidevice location module:
1. Select a device in Remote Manager that is configured to allow shell access to the admin user,
and click Actions > Open Console. Alternatively, log into the TX40 local command line as a
user with shell access.
Depending on your device configuration, you may be presented with an Access selection
menu. Type shell to access the device shell.
2. At the shell prompt, use the python command with no parameters to enter an interactive
Python session:
TX40 User Guide
44.926195299999998,
-93.397084499999999,
273.20001200000002
Develop Python applications
804