Table of Contents
Advertisement
Services
n
To limit access to specified IPv6 addresses and networks:
(config)> add service ssh acl address6 end value
(config)>
Where value can be:
A single IP address or host name.
l
A network designation in CIDRnotation, for example, 2001:db8::/48.
l
any: No limit to IPv6 addresses that can access the SSH service.
l
Repeat this step to list additional IP addresses or networks.
n
To limit access to hosts connected through a specified interface on the TX40 device:
(config)> add service ssh acl interface end value
(config)>
Where value is an interface defined on your device.
Repeat this step to list additional interfaces.
n
To limit access based on firewall zones:
(config)> add service ssh acl zone end value
(config)>
Where value is a firewall zone defined on your device, or the any keyword.
TX40 User Guide
Display a list of available interfaces:
Use ... network interface ? to display interface information:
Display a list of available firewall zones:
Type ... firewall zone ? at the config prompt:
(config)> ... firewall zone ?
Zones: A list of groups of network interfaces that can be
referred to by packet
filtering rules and access control lists.
Additional Configuration
--------------------------------------------------------
-----------------------
any
dynamic_routes
edge
external
hotspot
internal
ipsec
loopback
setup
Configure SSH access
637
Advertisement
Table of Contents
