Digi TX40 User Manual page 177

Interfaces
(config)> network interface wan1 ipv4 address 192.168.3.1/24
(config)>
c. Enable the DHCP server:
(config)> network interface wan1 ipv4 dhcp_server enable true
(config)>
d. Disable SureLink:
(config)> network interface wan1 ipv4 surelink enable false
(config)>
5. (Optional) Configure IPv6:
a. Set the type to prefix_delegation:
(config)> network interface wan1 ipv6 type prefix_delegation
(config)>
6. Save the configuration and apply the change
(config)> save
Configuration saved.
>
7. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Add the WAN/ETH1 Ethernet port to the default LAN bridge
This procedure will add the WAN/ETH1 port to the default LAN bridge, which will configure the two
Ethernet ports on the device to function as a hub.
To add the WAN/ETH1 port to the LAN bridge:

Web
1. Log into Digi Remote Manager, or log into the local Web UI as a user with full Admin access
rights.
2. Access the device configuration:
Remote Manager:
a. Locate your device as described in
device.
b. Click the Device ID.
c. Click Settings.
d. Click to expand Config.
Local Web UI:
TX40 User Guide
Use Digi Remote Manager to view and manage your
Local Area Networks (LANs)
177