Update System Firmware; Upgrading From Releases Prior To Release - Digi TX40 User Manual

System administration
1. Select the device in Remote Manager and click Actions > Open Console, or log into the TX40
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Set a name for the device. This name will appear in log messages and at the command prompt.
(config)> system name 192.168.3.1
192.168.3.1(config)>
4. Set the contact for the device:
192.168.3.1(config)> system contact "Jane User"
192.168.3.1(config)>
5. Set the location for the device:
192.168.3.1(config)> system location "9350 Excelsior Blvd., Suite 700,
Hopkins, MN"
192.168.3.1(config)>
6. Set the banner for the device. This is displayed when users access terminal services on the
device.
192.168.3.1(config)> system banner "Welcome to the Digi TX40."
192.168.3.1(config)>
7. Save the configuration and apply the change
192.168.3.1(config)> save
Configuration saved.
192.168.3.1>
8. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Update system firmware

The TX40 operating system firmware images consist of a single file with the following naming
convention:
platform-version.bin
For example, TX40-23.9.74.0.bin.

Upgrading from releases prior to release

If you are upgrading your TX40 device by using the local Web UI, you must first upgrade to release
22.2 prior to upgrading to the current release.
TX40 User Guide
Update system firmware
969