Table of Contents
Advertisement
Central management
where value is one of 1, 5, 15, 30, or 60, and represents the number of minutes between
uploads of health sample data.
5. Save the configuration and apply the change
(config)> save
Configuration saved.
>
6. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Reach Digi Remote Manager on a private network
If your company has a private network and you have devices that need to reach Digi Remote Manager,
there are several methods available:
n
Pinhole: a communication port on your network not protected by the firewall which allows the
application on the device to reach Digi Remote Manager.
n
Proxy server: a dedicated software system equipped with its own IP address that runs on your
network and acts as an intermediary between the device and Digi Remote Manager.
n
VPN Tunnel: a virtual private network that offers a secure, encrypted connection between a
device and the internet.
Pinhole method
Using the pinhole method requires your network administrator to remove the firewall connection on a
communication port. For more information, see
Digi Remote
Manager.
Proxy server method
The device is capable of connecting through an HTTP proxy, such as Squid, but it is up to the network
administrator to decide which HTTP proxy type to use.
To enable a proxy server and enter the server and port in Digi Remote Manager, see step 17 in
Configure your device for Digi Remote Manager
Tip
To see instructions for setting up Squid and then configuring a device (not DAL) to reach Digi
Remote Manager, see the Digi Quick Note,
Though this Quick Note references older technology and device types, it may provide a network
administrator with concrete examples from which they can draw correlations to newer technology
and devices.
VPN Tunnel method
Configuring a VPN tunnel to communicate with Digi Remote Manager is a two-step process. One step
is done by your organization's network administrator and the other by Digi Support.
Step 1: Set up the VPN tunnel
Your organization's network administrator needs to set up a VPN tunnel on your network, which will
be used to communicate with Digi Remote Manager through the Digi cloud service.
TX40 User Guide
Reach Digi Remote Manager on a private network
Firewall concerns for outbound EDP connections to
support.
Connecting to Digi Remote Manager Through Web
Proxy.
64
Advertisement
Table of Contents
