Digi TX40 User Manual page 375

Hotspot
Current value:
(config network wifi ap new_hotspot_AP1)>
ii. Set the appropriate radio:
(config network wifi ap new_hotspot_AP1)> radio wifi1
(config network wifi ap new_hotspot_AP1)>
c. Set the SSID:
(config network wifi ap new_hotspot_AP1)> ssid my_SSID
(config network wifi ap new_hotspot_AP1)>
This will be the SSID used by clients to connect to the hotspot. If you are creating multiple
access points, each access point must have the same SSID. Up to 32 characters are
allowed.
d. Set the encryption to open:
(config network wifi ap new_hotspot_AP1)> encryption type none
(config network wifi ap new_hotspot_AP1)>
Hotspot access points must use open (unencrypted) communication. See
for more information.
e. Type ... to return to the config prompt:
(config network wifi ap new_hotspot_AP1)> ...
(config)>
f. Add additional access points by following the above instructions.
4. (Optional) Create a new bridge and interface for the hotspot.
Note Hotspot bridges must also be part of an interface with a configured IP address.
a. Create a bridge:
(config)> add network bridge new_hotspot_bridge
(config network bridge new_hotspot_bridge)>
b. Add devices to the bridge:
i. Determine available devices:
(config network bridge new_hotspot_bridge)> .. .. interface lan1
device ?
Default value: /network/bridge/lan1
Current value: /network/bridge/lan1
TX40 User Guide
wifi1
wifi2
Hotspot configuration
Hotspot security
375