Use Policy Routes With Hotspot; Create A New Hotspot - Digi TX40 User Manual

Hotspot

Use policy routes with hotspot

When creating policy routes for hotspots, the source address should be set to use the hotspot zone:

Web
1. Create a new routing policy. See
2. During configuration, for Source address:
a. For Type, select Zone.
b. For Zone, select hotspot.
3. Click Apply to save the configuration and apply the change.

Command line
1. Create a new routing policy. See
2. During configuration, set the source address type to zone:
(config network route policy 0)> src type zone
(config network route policy 0)>
3. Set the zone to hotspot:
(config network route policy 0)> src zone hotspot
(config network route policy 0)>
4. Save the configuration and apply the change
(config)> save
Configuration saved.
>
5. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Create a new hotspot

Required configuration items
n A device or bridge for the hotstpot.
If a bridge is used, it must be included in an interface with an assigned IP address.
l
n The authentication mode:
If Local shared password is selected for the authentication mode, include the password.
l
If RADIUS shared password or RADIUS users is selected for the authentication mode,
l
include RADIUS configuration information.
If HotspotSystem is selected for the authentication mode, include HotspotSystem
l
configuration information.
See Hotspot authentication modes
TX40 User Guide
Configure a routing policy
Configure a routing policy
for more information about authentication modes.
Hotspot configuration
for instructions.
for instructions.
368