Table of Contents
Advertisement
Services
The Configuration window is displayed.
3. Click Network > Ethernet bonding.
4. For Add Bond device, click
The bond device is enabled by default. To disable, toggle off Enable.
5. For Mode, selected either:
Active-backup: Transmits data on only one of the bonded devices at a time. When the
n
active device fails, the next available device in the list is chosen. This mode provides for
fault tolerance.
Round-robin: Alternates between bonded devices to provide load balancing as well as
n
fault tolerance.
6. Click to expand Devices.
7. Add Ethernet devices:
a. For Add device, click .
b. For Device, select an Ethernet device to participate in the bond pool.
c. Repeat for each appropriate Ethernet device.
TX40 User Guide
Ethernet network bonding
738
Advertisement
Table of Contents
