Table of Contents
Advertisement
Services
Configure the ping responder service
Your TX40 device's ping responder service replies to ICMP and ICMPv6 echo requests. The service is
enabled by default. You can disable the service, or you can configure the service to use an access
control list to limit the service to specified IP address, interfaces, and/or zones.
To enable the iPerf3 server:
Web
1. Log into Digi Remote Manager, or log into the local Web UI as a user with full Admin access
rights.
2. Access the device configuration:
Remote Manager:
a. Locate your device as described in
device.
b. Click the Device ID.
c. Click Settings.
d. Click to expand Config.
Local Web UI:
a. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Services > Ping responder.
The ping responder service is enabled by default. Click Enable to disable all ping responses.
4. Click to expand Access control list to restrict ping responses to specified IP address,
interfaces, and/or zones:
n
To limit access to specified IPv4 addresses and networks:
a. Click IPv4 Addresses.
b. For Add Address, click .
c. For Address, enter the IPv4 address or network that can access the device's ping
d. Click again to list additional IP addresses or networks.
n
To limit access to specified IPv6 addresses and networks:
a. Click IPv6 Addresses.
b. For Add Address, click .
TX40 User Guide
responder. Allowed values are:
A single IP address or host name.
l
A network designation in CIDRnotation, for example, 192.168.1.0/24.
l
any: No limit to IPv4 addresses that can access the ping responder.
l
Configure the ping responder service
Use Digi Remote Manager to view and manage your
769
Advertisement
Table of Contents
