Digi TX40 User Manual page 326

Wi-Fi
Configure a new access point
1. Select the device in Remote Manager and click Actions > Open Console, or log into the TX40
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Create a new access point:
(config)> add network wifi ap new_AP
(config network wifi ap new_AP)>
New access points are enabled by default.
4. Set the Wi-Fi radio for the new access point:
a. Show available radios:
(config network wifi ap new_AP)> radio ?
Radio: The Wi-Fi radio to run this access point on.
Format:
wifi1
wifi2
Current value:
(config network wifi ap new_AP)>
b. Set the appropriate radio:
(config network wifi ap new_AP)> radio wifi1
(config network wifi ap new_AP)>
5. Set the SSID for the Wi-Fi access point. Up to 32 characters are allowed.
(config network wifi ap new_AP)> ssid my_SSID
(config network wifi ap new_AP)>
SSID broadcasting is enabled by default for new access points.
6. Set the security for the access point to an enterprise security option:
(config network wifi ap new_AP)> encryption type value
(config network wifi ap new_AP)>
where value is either:
wpa2: Uses WPA2 enterprise security mode.
n
wpa3: Uses WPA3 enterprise security mode.
n
TX40 User Guide
Configure a Wi-Fi access point with enterprise security
326