Change The Default Password For The Admin User - Digi TX40 User Manual

Firmware configuration
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Enable Primary Responder mode:
(config)> system primaryresponder true
(config)>
4. Save the configuration and apply the change
(config)> save
Configuration saved.
>
5. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Change the default password for the admin user

The unique, factory-assigned password for the default admin user account is printed on the bottom
label of the device and on the loose label included in the package.
If you erase the device configuration or reset the device to factory defaults, the password for the
admin user will revert to the original, factory-assigned default password.
To change the default password for the admin user:

Web
1. Log into Digi Remote Manager, or log into the local Web UI as a user with full Admin access
rights.
2. Access the device configuration:
Remote Manager:
a. Locate your device as described in
device.
b. Click the Device ID.
c. Click Settings.
d. Click to expand Config.
Local Web UI:
a. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
TX40 User Guide
Change the default password for the admin user
Use Digi Remote Manager to view and manage your
39