Show Lan Status And Statistics - Digi TX40 User Manual

Interfaces
d. Configure the IPv4 address for the LAN2 interface:
(config network interface LAN2)> ipv4 address 192.168.4.1/24
(config network interface LAN2)>
e. Enable the DHCP server for the LAN2 interface:
(config network interface LAN2)> ipv4 dhcp_server enable true
(config network interface LAN2)>
5. Save the configuration and apply the change
(config network interface LAN2)> save
Configuration saved.
>
6. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Task four: Verify the new configuration
The final step in this example is to verify the new configuration.
1. Verify that LAN1 is operating correctly:
a. Connect a device to LAN1 through the ETH1 Ethernet port, or by connecting to the
Example_AP Wi-Fi1 access point.
b. Verify that the device has been provided an IP address from the LAN DHCP server in the
192.168.3.* subnet.
2. Verify that LAN2 is operating correctly:
a. Connect a device to LAN2 through the ETH2 Ethernet port.
b. Verify that the device has been provided an IP address from the LAN2 DHCP server in the
192.168.4.* subnet.

Show LAN status and statistics


Web
Log into the TX40 WebUI as a user with full Admin access rights.
1. From the menu, click Status.
2. Under Networking, click Interfaces.

Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the TX40
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
TX40 User Guide
Local Area Networks (LANs)
193