Table of Contents
Advertisement
Services
a. Use the ? to determine available zones:
(config)> network sdwan wan_bonding zone ?
Zone: The zone for the new bonded interface. To treat the interface as
a typical
WAN interface, this should be set to External.
Format:
any
dynamic_routes
edge
external
hotspot
internal
ipsec
loopback
setup
Default value: external
Current value: external
(config)>
b. Set the zone:
(config)> network sdwan wan_bonding zone zone
(config)>
8. Configure the device's WAN interfaces that will be bonded:
a. Add the first interface:
(config)> add network sdwan wan_bonding interfaces end
(config network sdwan wan_bonding interfaces 0)>
i. Set the interface:
i. Use the ? to determine available interfaces:
ii. Set the interface. For example:
ii. (Optional) Set the mode for the interface:
(config network sdwan wan_bonding interfaces 0)> mode value
(config network sdwan wan_bonding interfaces 0)>
where value is one of:
TX40 User Guide
(config network sdwan wan_bonding interfaces 0)> interface
/network/interface/wan1
(config network sdwan wan_bonding interfaces 0)>
n
auto: Automatically sets the mode to Cellular Optimized for Speed-mode for
cellular, and Ethernet for non-cellular. This is the default mode.
mobileAggressive: A general-purpose configuration suitable for most lines
n
(4G, DSL, etc), with a fair tolerance for packet loss and latency.
WAN bonding
662
Advertisement
Table of Contents
