Table of Contents
Advertisement
Wi-Fi
To move the Drop traffic from Internal to LAN2_isolation_zone filter to the top of the
list:
i. Click the filter title.
ii. Drag-and-drop the filter to the top of the list.
4. Create a new LAN:
By default, the TX40 device comes with one preconfigured LAN, which includes the default
access points. We will use that LAN for the Digi AP (Wi-Fi1) access point, and create a new LAN
for the Digi AP (Wi-Fi2) access point. In this step, we create a new LAN for the Digi AP (Wi-Fi2)
access point; in the next step, we will remove the Digi AP (Wi-Fi2) access point from the
default bridge (and thus from the default LAN).
a. Click Configuration > Network > Interfaces.
b. For Add interface, type a name for the LAN and click .
c. For Zone, select LAN2_isolation_zone.
d. For Device, select Wi-Fi access point: Digi AP (Wi-Fi2).
e. Click to expand IPv4.
f. For Address, type an IP address and subnet for the LAN.
g. Click to expand DHCP server.
h. Enable the DHCP server.
5. Remove the Digi AP (Wi-Fi2) access point from the LAN1 bridge:
a. Click Network > Bridges > LAN1.
b. Click the down arrow () next to the the Digi AP (Wi-Fi2) access point and select Delete.
6. Click Apply to save the configuration and apply the change.
Command line
TX40 User Guide
Isolate Wi-Fi clients
334
Advertisement
Table of Contents
