Table of Contents
Advertisement
Serial port
iv. (Optional) Enable mDNS. mDNS is a protocol that resolves host names in small
networks that do not have a DNS server.
(config serial USB_port)> service ssh mdns enable true
(config serial USB_port)>
8. Save the configuration and apply the change
(config serial USB_port)> save
Configuration saved.
>
9. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
TX40 User Guide
Display a list of available interfaces:
Use ... network interface ? to display interface information:
Repeat this step to list additional interfaces.
To limit access based on firewall zones:
n
(config serial USB_port)> add service ssh acl zone end value
(config serial USB_port)>
Where value is a firewall zone defined on your device, or the any keyword.
Display a list of available firewall zones:
Type ... firewall zone ? at the config prompt:
(config serial USB_port)> ... firewall zone ?
Zones: A list of groups of network interfaces that
can be referred to by packet
filtering rules and access control lists.
Additional Configuration
-------------------------------------------------
------------------------------
any
dynamic_routes
edge
external
hotspot
internal
ipsec
loopback
setup
(config serial USB_port)>
Repeat this step to include additional firewall zones.
Add a USB serial port
294
Advertisement
Table of Contents
