Digi TX40 User Manual page 372

Hotspot
See
configuring hotspot for RADIUS users authentication.
n HotspotSystem: Requires each user to be authenticated by HotspotSystem, a cloud
hotspot service that supports various free and paid authentication methods, including
social media account, SMS, voucher, and PayPal.
See
configuring hotspot for HotspotSystem authentication.
11. For Login page source, select either:
Local: Uses an HTML page for authentication that is stored locally on the TX40 device's
n
filesystem, in the /etc/config/hotspot directory. Note that the hotspot directory is not
visible until hotspot has been enabled for the first time.
Remote: Uses an HTML page for authentication that is served by a remote web server.
n
This parameter is not available if HotspotSystem is selected for the Authentication mode.
12. (Optional) If Local is selected for Login page source, for Login page, type the name of the
local HTML file used for authentication. This parameter is not available if HotspotSystem is
selected for the Authentication mode.
Normally, this field should be left blank, and the device will use the default authentication
HTML page. See
authentication HTML page used for each authentication mode.
If you upload a custom HTML file that uses a filename other than the default filename, type the
custom filename here. See
creating and uploading custom HTML files.
13. (Optional) For Authentication port, type the port number that the hotspot authentication
server will used. The default is 3990.
14. (Optional) For Server port, type the port number of the hotspot server. The default is 4990.
15. If Remote is selected for Login page source, click to expand Remote web server.
a. For FQDN, type the IP address or fully-qualified domain name or the remote web server
that will be used for client authentication.
b. (Optional) For Secret, type the shared secret that the remote server and the hotspot. Used
with cloud-based hotspot providers.
c. (Optional) Change the default DHCP server configuration.
Note The hotspot DHCP server is automatically enabled and cannot be disabled.
i. Click to expand DHCP server.
ii. For Lease time, type the amount of time that a client DHCP lease is valid. The default
is 10 minutes.
TX40 User Guide
Configure the hotspot to use RADIUS users authentication
Configure the hotspot to use HotspotSystem authentication
Hotspot authentication modes
Upload custom hotspot HTML pages
Hotspot configuration
for information about
for information about
for information about the default
for more information about
372