Table of Contents
Advertisement
Interfaces
5. Click Apply to save the configuration and apply the change.
The TX40 device is now configured to use the cellular modem WWAN, WWAN1, as its highest priority
WAN, and its Ethernet WAN, WAN, as its secondary WAN.
Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the TX40
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Set the metrics for WWAN1:
a. Set the IPv4 metric for WWAN1 to 1. For example:
(config)> network interface wwan1 ipv4 metric 1
(config)>
b. Set the IPv6 metric for WWAN1 to 1:
(config)> network interface wwan1 ipv6 metric 1
(config)>
4. Set the metrics for WAN:
a. Set the IPv4 metric for WAN to 2:
(config)> network interface wan1 ipv4 metric 2
(config)>
b. Set the IPv6 metric for WAN to 1:
TX40 User Guide
Wide Area Networks (WANs)
75
Advertisement
Table of Contents
