Tx40 Leds; Wi-Fi - Digi TX40 User Manual

Digi TX40 hardware reference
Number Item
1 Serial port
2 USB port
3 SIMs
4 Reset
button
5 WAN/ETH1
6 ETH2
7 LEDs

TX40 LEDs

The TX40 LEDs are located on the top front panel. The number of LEDs varies by model. During
bootup, the front-panel LEDs light up in sequence to indicate boot progress.
WWAN
Indicates strength of cellular signal.
Off: No service.
n
Flashing Yellow on the interface: No Signal / No connection or SureLink is failing.
n
Flashing Green: 3Gconnection with poor or low signal strength.
n
Solid Green: 3Gconnection with good or excellent signal strength.
n
Flashing Blue: 4Gconnection with poor or low signal strength.
n
Solid Blue: 4Gconnection with good or excellent signal strength.
n
Flashing Magenta: 5Gconnection with poor or low signal strength.
n
Solid Magenta: 5Gconnection with good or excellent signal strength.
n

Wi-Fi

Solid Green: Wi-Fi access points or Wi-Fi clients are enabled.
n
Off: No Wi-Fi access points or Wi-Fi clients are enabled.
n
TX40 User Guide
Decription
RS232 DTE serial port with DB9 male connector. See
connector pinout.
USB 3.0
Uses 4FF Nano SIMs. See Install SIM
See Erase device configuration and reset to factory
Gigabit Ethernet port, WAN-enabled by default.
Gigabit Ethernet port, LAN-enabled by default.
See TX40 LEDs.
Digi TX40 serial
cards.
defaults.
TX40 LEDs
22