Digi TX40 User Manual page 278

Serial port
iv. Click  again to list additional IP addresses or networks.
n
n
n
d. Toggle on Enable mDNS to enable Multicast DNS (mDNS) reporting for this service. This
feature is disabled by default.
19. Expand Logging Settings to configure logging for this serial port.
a. To enable logging, click to toggle on Enable.
b. In the Log file name field, enter a descriptive name for the log file.
c. For Log file size, type the size of the log file. When the log file reaches the size limit, the
current file is saved and a new file is created. The default is 65536 bytes.
d. From the Type of data to log list box, specify the type of data that should be saved.
n
n
n
n
e. If you want to log the time at which date was received or transmitted, click the
Timestamps toggle to Enable.
f. If you want to log the data as hexadecimal values, click the Hexadecimal toggle to
Enable.
Note You can review the message log in the Serial Port Log page. See
port message
20. Click Apply to save the configuration and apply the change.
TX40 User Guide
To limit access to specified IPv6 addresses and networks:
i. Click IPv6 Addresses.
ii. For Add Address, click .
iii. For Address, enter the IPv6 address or network that can access the device's
service-type. Allowed values are:
A single IP address or host name.
l
A network designation in CIDRnotation, for example, 2001:db8::/48.
l
any: No limit to IPv6 addresses that can access the service-type.
l
iv. Click  again to list additional IP addresses or networks.
To limit access to hosts connected through a specified interface on the TX40 device:
i. Click Interfaces.
ii. For Add Interface, click .
iii. For Interface, select the appropriate interface from the dropdown.
iv. Click  again to allow access through additional interfaces.
To limit access based on firewall zones:
i. Click Zones.
ii. For Add Zone, click .
iii. For Zone, select the appropriate firewall zone from the dropdown.
See Firewall configuration
iv. Click  again to allow access through additional firewall zones.
Received
Transmitted
Both
Both with arrows. This is the default.
log.
Configure Modem emulator mode
for information about firewall zones.
Review the serial
278