Digi TX40 User Manual page 610

Virtual Private Networks (VPN)
2. To view configuration details about an L2TPV3 tunnel, click the  (configuration) icon in the
upper right of the tunnel's status pane.

Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the TX40
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. To display details about all configured L2TPv3 Ethernet tunnels, type the following at the
prompt:
> show l2tpeth
Tunnel Session
-----------------
test/session/test
>
3. To display details about a specific tunnel:
> show l2tpeth name /vpn/l2tpeth/test/session/test
test/session/test Tunnel Session Status
---------------------------------------
Enabled
Status
Local IP
Remote IP
Tunnel ID
Peer Tunnel ID
Session ID
Peer Session ID
Lifetime (Actual)
Device
RX Packets
RX Bytes
TX Packets
TX Byptes
>
4. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
TX40 User Guide
Enabled Device
------- ------------
true le_test_test
: true
: up
: 4.3.2.1
: 10.10.10.1
: wwan1
: 10.10.10.1 === 4.3.2.1
: 255
: 1476
: 600
: le_test_test
: 2,102
: 462
: 2,787
: 3,120
L2TPv3 Ethernet
Status
------
up
610