Digi TX40 User Manual page 752

Services
f. (Optional) Set the port to forward ITxPT GNSS information to. The default is 14005.
(config)> service location itxpt port int
(config)>
g. (Optional) Set the IPv4 or IPv6 address to forward ITxPT GNSS information to. The default
is 239.255.42.21.
(config)> service location itxpt address IP_address
(config)>
See Location information
9. Configure the NTP service for ITxPT:
a. Enable the NTP service:
(config)> service ntp enable true
(config)>
b. Enable the device to include NTP information with ITxPT support:
(config)> service ntp itxpt enable true
(config)>
c. Set the priority for NTP information. A lower number represents higher priority.
(config)> service ntp itxpt priority int
(config)>
The default is 0.
d. Set the relative weight for records with same priority. A higher number means that records
from this service are more preferred.
(config)> service ntp itxpt weight int
(config)>
The default is 0.
See Network Time Protocol
10. Configure the MQTT service for ITxPT:
a. Enable the MQTT service:
(config)> service mqtt enable true
(config)>
b. Enable the device to include MQTT messages with ITxPT support:
(config)> service mqtt itxpt enable true
(config)>
c. Set the priority for location information. A lower number represents higher priority.
(config)> service mqtt itxpt priority int
(config)>
TX40 User Guide
Information Technology for Public Transport (ITxPT) support
for more information about the GNSS location service.
for more information about the NTP service.
752