Show Status And Statistics Of The Ntp Server - Digi TX40 User Manual

Services
...
(config)>
9. Save the configuration and apply the change
(config)> save
Configuration saved.
>
10. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Show status and statistics of the NTP server

You can display status and statistics for active NTP servers

Web
Log into the TX40 WebUI as a user with full Admin access rights.
1. On the main menu, click Status.
2. Under Services, click NTP.
The NTP server status page is displayed.

Command line
Show NTP information
1. Select the device in Remote Manager and click Actions > Open Console, or log into the TX40
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. Use the show ntp
> show ntp
NTP Status Status
-----------------
Status
Sync Status : Up
Remote
Offset Jitter
----------------
- ------
*ec2-52-2-40-158
+1.561 0.991
128.136.167.120
TX40 User Guide
command at the system prompt:
: Up
Refid
-------------
129.6.15.32
128.227.205.3
ST T When Poll Reach
-- - ---- ---- -----
2 u 191 1024 377
3 u 153 1024 1
Network Time Protocol
Delay
------ -----
33.570
43.583 -
734