Delete An Authentication Group - Digi TX40 User Manual

User authentication
(config)>
ii. Add a captive portal:
(config)> add auth group test acl portal portals end portal1
(config)>
6. (Optional) Configure Nagios monitoring:
(config)> auth group test acl nagios enable true
(config)>
7. (Optional) Enable users that belong to this group to access the Wi-Fi scanning service:
(config)> auth group group test acl wifi_scanner enable true
(config)>
8. Save the configuration and apply the change
(config)> save
Configuration saved.
>
9. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Delete an authentication group

By default, the TX40 device has two preconfigured authentication groups: admin and serial. These
groups cannot be deleted.
To delete an authentication group that you have created:

Web
1. Log into Digi Remote Manager, or log into the local Web UI as a user with full Admin access
rights.
2. Access the device configuration:
Remote Manager:
a. Locate your device as described in
device.
b. Click the Device ID.
c. Click Settings.
d. Click to expand Config.
TX40 User Guide
no redirect_url
no terms
timeout 24h
no title
Use Digi Remote Manager to view and manage your
Authentication groups
849