Digi TX40 User Manual page 186

Interfaces
4. For Add Wi-Fi access point, type Example_AP for the name of the new access point and click
.
The Wi-Fi access point configuration window is displayed.
5. For SSID, type Example_SSID.
6. Type a Pre-shared key that clients will use to access the AP.
7. Click Apply to save the configuration and apply the change.

Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the TX40
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Create a new access point:
(config)> add network wifi ap Example_AP
(config network wifi ap Example_AP)>
New access points are enabled by default.
4. Set the SSID for the Wi-Fi access point. Up to 32 characters are allowed.
(config network wifi ap Example_AP)> ssid Example_SSID
(config network wifi ap Example_AP)>
SSID broadcasting is enabled by default for new access points.
5. Set the security for the access point to WPA2:
(config network wifi ap Example_AP)> encryption type wpa2
(config network wifi ap Example_AP)>
TX40 User Guide
Local Area Networks (LANs)
186