Table of Contents
Advertisement
Serial port
(config)>serial port1 service ssh nodelay true
(config)>
v. (Optional) Configure access control:
TX40 User Guide
n
To limit access to specified IPv4 addresses and networks:
(config)> add serial port1 service ssh acl address end value
(config)>
Where value can be:
A single IP address or host name.
l
A network designation in CIDRnotation, for example, 192.168.1.0/24.
l
any: No limit to IPv4 addresses that can access the service-type.
l
Repeat this step to list additional IP addresses or networks.
n
To limit access to specified IPv6 addresses and networks:
(config)> add serial port1 service ssh acl address6 end value
(config)>
Where value can be:
A single IP address or host name.
l
A network designation in CIDRnotation, for example, 2001:db8::/48.
l
any: No limit to IPv6 addresses that can access the service-type.
l
Repeat this step to list additional IP addresses or networks.
n
To limit access to hosts connected through a specified interface on the TX40
device:
(config)> add serial port1 service ssh acl interface end
value
(config)>
Where value is an interface defined on your device.
Display a list of available interfaces:
Use ... network interface ? to display interface information:
Repeat this step to list additional interfaces.
To limit access based on firewall zones:
n
(config)> add serial port1 service ssh acl zone end value
(config)>
Where value is a firewall zone defined on your device, or the any keyword.
Display a list of available firewall zones:
Configure Remote Access mode
250
Advertisement
Table of Contents
