Change The Default Hotspot Ip Address And Subnet - Digi TX40 User Manual

Hotspot
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Change the SSID for digi_hotspot_ap1 to your preferred value:
(config)> network wifi ap digi_hotspot_ap1 ssid value
where value is a string of 1 to 32 characters. If the value contains spaces, enclose in quote
marks (").
4. Change the SSID for digi_hotspot_ap2 to your preferred value:
(config)> network wifi ap digi_hotspot_ap1 ssid value
where value is a string of 1 to 32 characters. If the value contains spaces, enclose in quote
marks (").
5. Save the configuration and apply the change
(config)> save
Configuration saved.
>
6. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Change the default hotspot IP address and subnet

Required configuration items
Enable default hotspot configuration. See
n
instructions.
An IP address and subnet for the hotspot.
n
Additional configuration items
Hotspot DHCP server settings:
n
Lease time.
l
Lease range start and end.
l
To change the default hotspot IP address and subnet:

Web
1. Log into Digi Remote Manager, or log into the local Web UI as a user with full Admin access
rights.
2. Access the device configuration:
Remote Manager:
TX40 User Guide
Enable hotspot using the default configuration
Hotspot configuration
for
360