Digi TX40 User Manual page 819

Applications
n Remove the script from the device and add it again.
n Make a change to the script.
n Uncheck Once.
12. Click Apply to save the configuration and apply the change.

Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the TX40
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Add a script:
(config)> add system schedule script end
(config system schedule script 0)>
Scheduled scripts are enabled by default. To disable:
(config system schedule script 0)> enable false
(config system schedule script 0)>
4. (Optional) Provide a label for the script.
(config system schedule script 0)> label value
(config system schedule script 0)>
where value is any string. if spaces are used, enclose value within double quotes.
5. Set the mode that will be used to run the script:
(config system schedule script 0)> when mode
(config system schedule script 0)>
where mode is one of the following:
boot: The script will run once each time the device boots.
n
If boot is selected, set the action that will be taken when the script completes:
l
where action is one of the following:
o
o
o
interval: The script will start running at the specified interval, within 30 seconds after
n
the configuration change is saved. If interval is selected:
TX40 User Guide
(config system schedule script 0)> exit_action action
(config system schedule script 0)>
none: Action taken when the script exits.
restart: Runs the script repeatedly.
reboot: The device will reboot when the script completes.
Set up the TX40 to automatically run your applications
819